Anti-Lock Brake System ABS Diagnostic Trouble Code (DTC) Index
WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
ANTI-LOCK BRAKE SYSTEM ABS DIAGNOSTIC TROUBLE CODE (DTC) INDEX
| DTC | Description | Source | Action |
|---|---|---|---|
| B1317 | Battery Voltage High | ABS Module | GO to PINPOINT TEST B . |
| B1318 | Battery Voltage Low | ABS Module | GO to PINPOINT TEST B . |
| B1342 | ECU is Faulted | ABS Module | REPAIR all other DTCs. CLEAR the DTCs. TEST the system for normal operation. If the DTC returns, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . |
| B2477 | Module Configuration Failure | ABS Module | CONFIGURE the ABS module. REFER to MODULE CONFIGURATION . CLEAR the DTCs. REPEAT the self-test. If DTC B2477 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . REPEAT the self-test. |
| B2900 | VIN Mismatch | ABS Module | CHECK for the correct VIN number in the VID block of the PCM. CONFIGURE the ABS module. REFER to MODULE CONFIGURATION . Use Programmable Module Installation (PMI) for the ABS module. CLEAR the DTCs. REPEAT the self-test. If DTC B2900 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . REPEAT the self-test. |
| C110A | ABS Active Circuit Short to Battery | ABS Module | If any other DTC(S) are present, diagnose those DTC(s) first. CLEAR all DTC(s). DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| C1095 | ABS Hydraulic Pump Motor Circuit Failure | ABS Module | GO to PINPOINT TEST C . |
| C1096 | ABS Hydraulic Pump Motor Circuit Open | ABS Module | GO to PINPOINT TEST C . |
| C1115 | ABS Power Relay Output Short Circuit to Battery | ABS Module | CLEAR all DTCs. DRIVE the vehicle. If DTC C1115 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| C1145 | Wheel Speed RF Sensor Input Circuit Failure | ABS Module | GO to PINPOINT TEST D . |
| C1155 | Speed Wheel Sensor LF Input Circuit Failure | ABS Module | GO to PINPOINT TEST D . |
| C1175 | Speed Wheel Sensor Rear Input Circuit Failure | ABS Module | GO to PINPOINT TEST D . |
| C1185 | ABS Power Relay Output Circuit Failure | ABS Module | CLEAR all DTCs. If DTC C1185 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| C1194 | ABS Outlet Valve Coil LF Circuit Failure | ABS Module | CLEAR all DTCs. If DTC C1194 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| C1198 | ABS Inlet Valve Coil LF Circuit Failure | ABS Module | CLEAR all DTCs. If DTC C1198 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| C1210 | ABS Outlet Valve Coil RF Circuit Failure | ABS Module | CLEAR all DTCs. If DTC C1210 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| C1214 | ABS Inlet Valve Coil RF Circuit Failure | ABS Module | CLEAR all DTCs. If DTC C1214 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| C1222 | Wheel Speed Mismatch | ABS Module | GO to PINPOINT TEST E . |
| C1233 | Speed Wheel LF Input Signal Missing | ABS Module | GO to PINPOINT TEST E . |
| C1234 | Speed Wheel RF Input Signal Missing | ABS Module | GO to PINPOINT TEST E . |
| C1236 | Speed Wheel Rear Input Signal Missing | ABS Module | GO to PINPOINT TEST E . |
| C1242 | ABS Outlet Valve Coil LR Circuit Failure | ABS Module | CLEAR all DTC(s.) DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| C1246 | ABS Outlet Valve Coil RR Circuit Failure | ABS Module | CLEAR all DTC(s). DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| C1250 | ABS Inlet Valve Coil LR Circuit Failure | ABS Module | CLEAR all DTC(s). DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| C1254 | ABS Inlet Valve Coil RR Circuit Failure | ABS Module | CLEAR all DTC(s). DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| C1329 | ABS Valve Outlet Coil Over RF Temperature | ABS | CLEAR all DTCs. DRIVE the vehicle. IF DTC C1329 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied. |
| C1330 | ABS Valve Outlet Coil Over LR Temperature | ABS | CLEAR all DTCs. DRIVE the vehicle. IF DTC C1330 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied. |
| C1331 | ABS Valve Outlet Coil Over RR Temperature | ABS | CLEAR all DTCs. DRIVE the vehicle. IF DTC C1331 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied. |
| C1332 | ABS Valve Outlet Coil Over LF Temperature | ABS | CLEAR all DTCs. DRIVE the vehicle. IF DTC C1332 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied. |
| C1333 | ABS Valve Inlet Coil Over RF Temperature | ABS | CLEAR all DTCs. DRIVE the vehicle. IF DTC C1333 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied. |
| C1334 | ABS Valve Inlet Coil Over LR Temperature | ABS | CLEAR all DTCs. DRIVE the vehicle. IF DTC C1334 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied. |
| C1335 | ABS Valve Inlet Coil Over RR Temperature | ABS | CLEAR all DTCs. DRIVE the vehicle. IF DTC C1335 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied. |
| C1336 | ABS Valve Inlet Coil Over LF Temperature | ABS | CLEAR all DTCs. DRIVE the vehicle. IF DTC C1336 is retrieved again, INSTALL a new HCU. REFER to HYDRAULIC CONTROL UNIT (HCU) . CARRY OUT the self-test with the brake pedal not applied. |
| C1446 | Brake Switch Circuit Failure | ABS Module | GO to PINPOINT TEST F . |
| C1730 | Reference Voltage Out of Range (+5V) | ABS Module | If any other DTC(s) are present, diagnose those DTC(s) first. CLEAR all DTCs. DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS. REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| U0073 | CAN Bus Off -Transmit Error | ABS Module | If any other DTC(s) are present, diagnose those DTC(s) first. CLEAR all DTCs. DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| U1900 | CAN Communication Bus Fault-Receive Error | ABS Module | REFER to MODULE COMMUNICATIONS NETWORK . |
| U2050 | No Application Present | ABS Module | If any other DTC(s) are present, diagnose those DTC(s) first. CLEAR all DTCs. DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |
| U2051 | One or More Calibration Files Missing/Corrupt | ABS Module | If any other DTC(s) are present, diagnose those DTC(s) first. CLEAR all DTCs. DRIVE the vehicle. If the DTC is still present, INSTALL a new ABS REFER to ANTI-LOCK BRAKE SYSTEM ABS MODULE . CARRY OUT the self-test with the brake pedal not applied. |