LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 908 (Fuel System & Engine Controls -- 6.8L (3V) -- F250-F550 Super Duty) >> Removal And Installation >> Throttle Body >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and can be ignited. Failure to follow these instructions may result in personal injury.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the air cleaner outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  3. Disconnect the electronic throttle control electrical connector.
  4. Disconnect the TP sensor electrical connector.
  5. Remove the 4 throttle body bolts and the throttle body and discard the throttle body gasket.
    • To install, tighten to 9 Nm (80 lb-in).
    • Tighten an additional 90 degrees.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals