LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 907 (Fuel System & Engine Controls -- 5.4L (3V) -- F250-F550 Super Duty) >> Removal And Installation >> Throttle Body >> Removal

Throttle Body: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and can be ignited. Failure to follow these instructions may result in personal injury.
CAUTION: The throttle body bore and plate area have a special coating and cannot be cleaned.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  3. Disconnect the electronic throttle control electrical connector.
  4. Disconnect the throttle position (TP) sensor electrical connector.
  5. Remove the 4 bolts and the throttle body (TB) assembly.
    • Discard the TB O-ring seal.
scientia non olet · About LEMON Manuals