LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 904 (Manual Transmission -- F250-F550 Super Duty) >> In-Vehicle Repair >> Seal - Output Oil >> Removal

Seal - Output Oil: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Raise and support the vehicle. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the rear driveshaft from the transmission and position it aside. For additional information, refer to DRIVESHAFT .

    3. Vehicles with 4-wheel drive 

  3. Remove the transfer case. For additional information, refer to TRANSFER CASE .
  4. Using the special tools, remove and discard the output oil seal.
    Fig 1: Removing Output Oil Seal
    G03923374Courtesy of FORD MOTOR CO.

    5. Vehicles with 2-wheel drive 

  5. Using the special tools, remove the transmission flange.
    Fig 2: Removing Transmission Flange
    G03923375Courtesy of FORD MOTOR CO.
  6. Remove and discard the output oil seal.
    Fig 3: Removing Output Oil Seal
    G03923376Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals