LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 904 (Manual Transmission -- F250-F550 Super Duty) >> In-Vehicle Repair >> Seal - Output Oil >> Installation

Seal - Output Oil: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    Vehicles with 4-wheel drive 

  1. Using the special tool, install a new output oil seal.
    • Coat the outer diameter of the new seal with gasket and trim adhesive.
      Fig 1: Installing Output Oil Seal (Vehicles With 4-Wheel Drive)
      G03923377Courtesy of FORD MOTOR CO.
  2. Install the transfer case. For additional information, refer to TRANSFER CASE .

    3. Vehicles with 2-wheel drive 

  3. Using the special tool, install a new output oil seal.
    • Coat the outer diameter of the new seal with gasket and trim adhesive.
      Fig 2: Installing Output Oil Seal (Vehicles With 2-Wheel Drive)
      G03923378Courtesy of FORD MOTOR CO.
  4. Apply Threadlock 262 to the threads of the transmission flange locknut. Using the special tools, install the transmission flange.
    Fig 3: Identifying Tightening Torque Of Transmission Flange Locknut
    G03923379Courtesy of FORD MOTOR CO.

    5. All vehicles 

  5. Connect the rear driveshaft. For additional information, refer to DRIVESHAFT .
scientia non olet · About LEMON Manuals