Transmission Drive Cycle Test: Notes

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If equipped, turn the power take-off (PTO) unit off for correct test results. For a description of PTO operation, refer to TRANSMISSION ELECTRONIC CONTROL SYSTEM .

NOTE: Always drive the vehicle in a safe manner according to driving conditions and obey all traffic laws.

NOTE: The Transmission Drive Cycle Test must be followed exactly. Malfunctions must occur four times consecutively for the shift error DTC to be set. Torque converter clutch (TCC) failures must occur five times consecutively for a continuous TCC DTC code to be set.

NOTE: When carrying out the Transmission Drive Cycle Test, refer to the solenoid operation chart for correct solenoid operation.

After carrying out the Quick Test, use the Transmission Drive Cycle Test for checking continuous codes.

Record and then erase the Quick Test codes.
Warm the engine to normal operating temperature.
Make sure the transmission fluid level is correct.
With the transmission range selector lever in (D), moderately accelerate from stop to 80 km/h (50 mph). This allows the transmission to shift into fifth gear. Hold the vehicle speed and throttle position steady for a minimum of 15 seconds.
With the transmission in fifth gear and a steady vehicle speed and throttle position, lightly apply and release the brake pedal enough to operate the stop lamps. Hold the vehicle speed and throttle position steady for a minimum of 15 seconds.
Brake to a stop and remain stopped for a minimum of 20 seconds.
Repeat Steps 4 through 6 at least five times.
Carry out Quick Test and record continuous codes.