LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 900 (Automatic Transmission -- F250-F550 Super Duty) >> Diagnosis And Testing >> Transmission Drive Cycle Test >> After On-Board Diagnostics

After On-Board Diagnostics

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The vehicle wiring harness, powertrain control module (PCM) and non-transmission sensors can affect transmission operations. Repair these concerns first.

After the On-Board Diagnostics procedures are completed, repair all DTCs.

Always repair all non-transmission-related DTCs first, then repair any transmission-related DTCs. Refer to the DIAGNOSTIC TROUBLE CODE CHART  for information on condition and symptoms. This chart will be helpful in referring to the correct manual(s) and to aid in diagnosing internal transmission concerns and external non-transmission inputs. The pinpoint tests are used in diagnosing electrical concerns of the transmission. Make sure the vehicle wiring harness and the PCM are diagnosed as well. The INTRODUCTION - GASOLINE article or INTRODUCTION -- 6.0L DIESEL article will aid in diagnosing non-transmission-related electronic components.

scientia non olet · About LEMON Manuals