On-Board Diagnostics with Diagnostic Tool

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For detailed instruction and other diagnostic methods using the diagnostic tool, refer to the tester manual and the INTRODUCTION - GASOLINE article or INTRODUCTION -- 6.0L DIESEL .

These quick tests should be used to diagnose the powertrain control module (PCM) and should be carried out in order.

Quick Test 1.0-Visual Inspection
Quick Test 2.0-Set Up
Quick Test 3.0-Key On, Engine Off
Quick Test 4.0-Continuous Memory
Quick Test 5.0-Key On, Engine Running
Special Test Mode
- Wiggle Test
- Output Test Mode
PCM Reset Mode
Clearing DTCs
OBD II Drive Cycle
Other NGS Features
For further information on other diagnostic testing features using the diagnostic tool, See INTRODUCTION - GASOLINE article or INTRODUCTION -- 6.0L DIESEL . Other diagnostic methods include the following.
- Parameter Identification (PID) Access Mode
- Freeze Frame Data Access Mode
- Oxygen Sensor Monitor Mode