Selecting & Viewing PIDs

WARNING: This page is about a different car, the 2002 Ford Pickup and 2002 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition off. Ensure test equipment is properly attached. Program scan tool using the following steps:

Turn ignition on or start engine and allow to idle.
Select VEHICLE & ENGINE SELECTION menu.
Select NEW VEHICLE, YEAR & MODEL.
Select DIAGNOSTIC DATA LINK.
Select AFCM-ALTERNATE FUEL CTRL MODULE. (AFCM supports similar DTCs and PIDs as PCM, but may have an entirely different meaning).
Select PID/DATA MONITOR AND RECORD.
Select PIDs and press trigger on NGS tester.
Press START to begin monitoring. If PID value is not as specified, perform appropriate SYSTEM TEST. See SYSTEM TESTS in SELF-DIAGNOSTICS - EEC-V - BI-FUEL article.