LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 899 (Engine System-General Information -- F250-F550 Super Duty (Gasoline)) >> General Procedures >> Valve Stem Diameter

Valve Stem Diameter

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the diameter of each intake and exhaust valve stem at the points shown. Verify the diameter is within specification.
    • Refer to the appropriate article for the procedure.
    • If out of specification, install new components as necessary. Refer to the appropriate article for the procedure.
      Fig 1: Measuring Diameter Of Valve Stem
      G03905280Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals