LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 899 (Engine System-General Information -- F250-F550 Super Duty (Gasoline)) >> General Procedures >> Connecting Rod to Crankshaft Side Clearance

Connecting Rod to Crankshaft Side Clearance

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the clearance between the connecting rod and the crankshaft. Verify the measurement is within specification.
    • Refer to the appropriate article for the procedure.
    • If out of specification, install new components as necessary. Refer to the appropriate article for the procedure.
      Fig 1: Measuring Connecting Rod To Crankshaft Side Clearance
      G04003850Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals