LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 895 (Electronic Engine Control System -- Gasoline Engines -- F250-F550 Super Duty) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All engines 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .

    4. 5.4L 3V engines 

  4. Remove the nut and position the starter wiring harness and support bracket aside.
    • To install, tighten to 10 Nm (89 lb-in).
      Fig 1: Locating Starter Wiring Harness Support Bracket Bolt
      G03919905Courtesy of FORD MOTOR CO.

    5. All engines 

  5. Disconnect the A/C compressor electrical connector.
  6. Remove the 3 bolts and position the A/C compressor aside.
    • To install, tighten to 25 Nm (18 lb-ft).
  7. Disconnect the CKP sensor electrical connector.
  8. Remove the bolt and the CKP sensor. Discard the O-ring seal.
    • To install, tighten to 10 Nm (89 lb-in).
    • Lubricate the new O-ring seal with clean engine oil prior to installation.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals