LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 895 (Electronic Engine Control System -- Gasoline Engines -- F250-F550 Super Duty) >> Removal And Installation >> Charge Motion Control Valve (CMCV) - 5.4L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to ENGINE - 5.4L (3V) .
  2. Disconnect the CMCV RH and LH rods from the intake manifold.
    • Lubricate the CMCV RH and LH rod ends with clean engine oil prior to installation.
  3. Remove the stud bolt, the 2 bolts and the CMCV.
    • To install, tighten to 6 Nm (53 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals