Drive Pinion Flange and Drive Pinion Seal: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Raise the vehicle on a hoist or raise the rear end of the vehicle with a jack. Install safety stands under the frame rails and lower the jack or hoist far enough to allow the rear axle to drop into the rebound position for working clearance.

NOTE: To maintain driveline balance, mark the driveshaft components so they can be reinstalled in their original positions.

Fig 1: Index-Marking On Driveshaft Flange Yoke And Pinion Flange

Courtesy of FORD MOTOR CO.

Disconnect the driveshaft at the rear axle and position it aside. For additional information, refer to DRIVESHAFT .

NOTE: Index-mark the flange to the pinion shaft.

Fig 2: Holding Pinion Flange With Special Tool

Courtesy of FORD MOTOR CO.

While using a suitable tool to prevent the flange or yoke from turning, remove the pinion nut.
Using the 2-Jaw Puller, remove the flange or yoke.

Fig 3: Removing Pinion Flange Using Special Tool
Courtesy of FORD MOTOR CO.
Using the Bushing Remover and the Slide Hammer, remove the pinion seal.

Fig 4: Removing Pinion Seal
Courtesy of FORD MOTOR CO.
Clean the rear axle pinion seal seat.