LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Removal, Overhaul & Installation) >> Ignition Systems >> Crankshaft Position Sensor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable. Crankshaft Position (CKP) sensor is located at rear of left cylinder head, near transaxle bellhousing. Remove Crankshaft Position (CKP) sensor heat shield. Disconnect CKP sensor harness connector. Remove CKP sensor bolt and remove CKP sensor. To install, reverse removal procedure. Tighten CKP sensor bolt. CKP sensor bolt torque specification is not available from manufacturer.

scientia non olet · About LEMON Manuals