Removal & Installation
WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect negative battery cable. Powertrain Control Module (PCM) is located behind glove box. Remove glove box. Remove 2 bolts retaining passenger side air bag bracket. Loosen connector bolt and disconnect PCM electrical connector from PCM. Disconnect 2 electrical connectors and relay from top of PCM. Remove 3 nuts retaining PCM and remove PCM. To install, reverse removal procedure. Tighten bracket bolts and connector bolt to specification. See TORQUE SPECIFICATIONS .