LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 877 (Acceleration Control System -- F250-F550 Super Duty) >> Removal And Installation >> Accelerator Pedal - Adjustable >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the accelerator pedal position sensor electrical connector.
  3. Disconnect the adjustable pedal motor electrical connector.
  4. Disconnect the adjustable pedal motor drive cable from the brake pedal assembly.
  5. Remove the 3 nuts and the accelerator pedal and position sensor assembly.
    • To install, tighten to 9 Nm (80 lb-in).
  6. Remove the 3 bolts and the adjustable pedal motor assembly and bracket.
    • To install, tighten to 25 Nm (18 lb-ft).
  7. To install, reverse the removal procedure.
    • The brake pedal and the accelerator pedal must be indexed when installing a new cable or a new adjustable pedal motor assembly. Index the adjustable pedal assemblies. For additional information, refer to HYDRAULIC BRAKE ACTUATION .
scientia non olet · About LEMON Manuals