LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 876 (Exhaust System -- F250-F550 Super Duty) >> Removal And Installation >> Muffler and Tailpipe >> Removal

Muffler and Tailpipe: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Exhaust fasteners are of a torque prevailing design. Use only new fasteners with the same part number as the original. Torque values must be used as specified during reassembly to make sure of correct retention of exhaust components.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Loosen the catalytic converter-to-muffler coupling or, if equipped, the exhaust intermediate pipe-to-muffler coupling.
  3. Remove and discard the 2 muffler rear bracket nuts.
    Fig 1: Removing Muffler Rear Bracket Nuts
    G03924089Courtesy of FORD MOTOR CO.
  4. Disconnect the rubber isolators and remove the muffler and tailpipe assembly.
scientia non olet · About LEMON Manuals