LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 869 (Transfer Case -- F250-F550 Super Duty) >> In-Vehicle Repair >> Transfer Case Front Output Shaft Seal >> Installation

Transfer Case Front Output Shaft Seal: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the special tools, install a new front output seal.
    Fig 1: Installing Front Output Seal
    G03923859Courtesy of FORD MOTOR CO.
  2. Install the front flange.
    • Use the special tool to prevent the flange from turning while installing a new nut.
      Fig 2: Installing Front Flange
      G03909773Courtesy of FORD MOTOR CO.
    3. CAUTION: Align the index marks.
  3. Install the front driveshaft. For additional information, refer to DRIVESHAFT .
  4. Check and, if necessary, fill the transfer case with the specified fluid to the specified level. For additional information, refer to TRANSFER CASE DRAINING AND FILLING .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals