LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 868 (Rear Suspension -- F250-F550 Super Duty) >> Removal And Installation >> Shock Absorber - F-450, F-550, Dana Axle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Suspension fasteners are critical components because they affect performance of vital components and systems and their failure can result in major service expense. Install new components with the same component number or an equivalent component if installation is necessary. Do not use an installation component of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these components.
CAUTION: The low pressure gas shock absorbers are charged with nitrogen gas. Do not attempt to open, puncture or apply heat to shock absorbers.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Using a suitable jack, support the rear axle.
  3. Remove the shock absorber lower retaining nut and bolt.
    Fig 1: Removing Shock Absorber Lower Retaining Nut And Bolt
    G03917922Courtesy of FORD MOTOR CO.
  4. Remove the nut from the upper shock absorber mounting bracket and remove the shock.
    Fig 2: Removing Nut From Upper Shock Absorber Mounting Bracket
    G03917923Courtesy of FORD MOTOR CO.
  5. To install, follow the removal procedure in reverse order, using new fasteners.
    Fig 3: Installing Shock Absorber Lower Retaining Nut And Bolt
    G03917924Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals