Driveshaft - Front, Visteon: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Install the front driveshaft with the index marks aligned.

NOTE: An extension must be used to tighten the driveshaft to transfer case bolts. Extensions change the calibration of the torque wrench. Use the torque wrench manual to calculate the correct settings.

NOTE: Install new bolts and retainers.

Fig 1: Identifying Special Tools

Courtesy of FORD MOTOR CO.

Fig 2: Installing Four Driveshaft Flange Bolts

Courtesy of FORD MOTOR CO.

Fig 3: Installing U-Joint Retainers Bolts

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.