LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 866 (Rear Disc Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Rear Brake Caliper >> Removal

Rear Brake Caliper: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
  1. Raise and support the vehicle. For additional information, refer to JACKING AND LIFTING .
  2. Remove the brake caliper flow bolt and discard the 2 copper washers.
    Fig 1: Removing Brake Caliper Flow Bolt
    G03919378Courtesy of FORD MOTOR CO.
  3. CAUTION: Do not pry in the caliper sight hole to retract the pistons, as this can damage the pistons and boots.
    Fig 2: Removing 2 Brake Caliper Bolts And Caliper
    G03919379Courtesy of FORD MOTOR CO.
  4. Remove the 2 brake caliper bolts and the caliper.