LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 852 (Safety Belt System) >> Diagnosis And Testing >> Safety Belt System >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern by operating the safety belt.
  2. Visually inspect for obvious signs of mechanical and electrical damage. Refer to the following VISUAL INSPECTION .
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Loose webbing
    • Safety belt retractor and tongue assembly
    • Blown fuse(s)
    • Damaged wiring harness
    • Loose or corroded connections
    • Warning chime module
    • Safety belt warning indicator switch
  3. If the fault is not visually evident, determine the symptom. GO to SYMPTOM CHART .