LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Engine Controls - Removal, Overhaul & Installation) >> Ignition Systems >> Camshaft Position Sensor >> Removal & Installation (2.0L)

Removal & Installation (2.0L)

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable. Disconnect Camshaft Position (CMP) sensor connector. Remove CMP sensor mounting bolt. Remove CMP sensor. To install, reverse removal procedure. Tighten CMP sensor mounting bolt to specification. See TORQUE SPECIFICATIONS .

scientia non olet · About LEMON Manuals