LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 849 (Door System - Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Hood Latch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pin-type retainers and the radiator sight shield.
    Fig 1: Locating Pin-Type Retainers And Radiator Sight Shield
    G03891075Courtesy of FORD MOTOR CO.
  2. Remove the hood latch.
    1. Remove the bolts.
    2. Remove the screw and disconnect the cable.
      Fig 2: Removing Hood Latch
      G03891076Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
    • Lower the hood to check the hood latch alignment.
scientia non olet · About LEMON Manuals