LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 848 (Windows And Glass - Glass, Frames And Mechanisms) >> General Procedures >> Door Window Glass Adjustment

Door Window Glass Adjustment

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel (23942); for additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Loosen, but do not remove, the window regulator bracket upper nuts.
    Fig 1: Locating Window Regulator Bracket Upper Nuts
    G03890980Courtesy of FORD MOTOR CO.
  3. Raise the front door window glass to the full up position, and tighten the nuts.
    Fig 2: Raising Front Door Window Glass
    G03890981Courtesy of FORD MOTOR CO.
  4. Loosen, but do not remove, the rear glass channel bolt.
    Fig 3: Locating Rear Glass Channel Bolt
    G03890982Courtesy of FORD MOTOR CO.
  5. Lower the front door window glass partway, to allow adjustment.
  6. Move the front door window glass to the rearward position, and tighten the bolt.
    Fig 4: Identifying Bolt Tightening Specification
    G03890983Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals