LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 848 (Windows And Glass - Glass, Frames And Mechanisms) >> Diagnosis And Testing >> Glass, Frames and Mechanisms >> Pinpoint Tests >> Pinpoint Test A: All Power Windows Are Inoperative

Pinpoint Test A: All Power Windows Are Inoperative

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. A1 CHECK THE SUPPLY VOLTAGE TO THE FUSE 
    • Remove the IP fuse panel Fuse 21 (30A).
      Fig 1: Locating IP Fuse Panel Fuse 21 (30A)
      G03890963Courtesy of FORD MOTOR CO.
    • Key in ON position.
    • Measure the voltage between the IP fuse panel Fuse 21 (30A) left terminal and ground.
      Fig 2: Measuring Voltage Between IP Fuse Panel Fuse 21 Left Terminal And Ground
      G03890964Courtesy of FORD MOTOR CO.
    • Is the voltage greater than 10 volts? 
    • Yes  : GO to A2.
    • No  : REPAIR Circuit 297 (BK/LG). TEST the system for normal operation.
  2. A2 CHECK THE LEFT CONTROL SWITCH GROUND CIRCUIT 
    • Key in OFF position.
    • Disconnect: Left Door Left Window Regulator Control Switch C508.
    • Measure the resistance between the left door left window regulator control switch connector C508, Circuit(s) 57 (BK) and ground.
      Fig 3: Measuring Resistance Between Left Door Left Window Regulator Control Switch Connector Circuit 57 (BK) And Ground
      G03890965Courtesy of FORD MOTOR CO.
    • Is the resistance less than 5 ohms? 
    • Yes  : REPAIR Circuit 170 (R/LB) between the IP fuse panel and the splice to the right window regulator control switch connector C629. TEST the system for normal operation.
    • No  : REPAIR Circuit 57 (BK). TEST the system for normal operation.
scientia non olet · About LEMON Manuals