LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 847 (Seat System) >> Removal And Installation >> Seat - Rear, Quad Bucket >> Removal

Seat - Rear, Quad Bucket: Removal

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disengage the detachable safety belt anchor.
    1. Insert a key or small screwdriver into the slot in the detachable anchor and lift upward.
    2. Disengage the detachable anchor tongue end from the detachable anchor.
      Fig 1: Disengaging Detachable Anchor Tongue End From Detachable Anchor
      G03890805Courtesy of FORD MOTOR CO.
  2. Pull the handle to release the rear bucket seat from the pedestal.
    Fig 2: Releasing Rear Bucket Seat From Pedestal
    G03890806Courtesy of FORD MOTOR CO.
  3. Slide the seat toward the right-hand side of the vehicle.
    Fig 3: Sliding Seat Toward Right-Hand Side Of Vehicle
    G03890807Courtesy of FORD MOTOR CO.
  4. Remove the rear bucket seat.