LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 845 (Body Closures) >> General Procedures >> Hinge Adjustment - Sliding, Center Roller

Hinge Adjustment - Sliding, Center Roller

WARNING: This page is about a different car, the 2005 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the sliding door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Loosen the center roller bolts.
    Fig 1: Removing Center Roller Bolts
    G03890665Courtesy of FORD MOTOR CO.
  3. Move the body side door center roller up and down or fore and aft until the desired adjustment is obtained.
  4. Tighten the center roller bolts.
    Fig 2: Tightening Center Roller Bolts
    G03890666Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals