LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 843 (Body Panel System - Body System - General Information) >> Diagnosis And Testing >> Body System >> Inspection and Verification >> Leaks

Inspection and Verification: Leaks

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The trim will reveal the location of most leaks. Use spray chalk and a hose, if necessary.
  1. Remove any trim or carpet in the general area of the leak.
  2. Road test or water hose test the vehicle.
  3. Inspect for a dust pattern around the area in question. Inspect for water paths near and above the area in question.
  4. Some leaks can be located by placing bright light under the vehicle, removing trim or carpet as necessary and inspecting the interior of the body at joints and weld lines.
scientia non olet · About LEMON Manuals