LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Controls - Removal, Overhaul & Installation -- ECONOLINE, Excursion & F250-F550 Super Duty - Gasoline) >> Fuel Systems >> Fuel Rails & Injectors >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Ford RV Cutaway, 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, and 2002 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Disconnect negative battery cable. Disconnect vacuum hose from fuel pressure regulator. Remove fuel hose clamps.
  2. Disconnect fuel supply and return line connections at fuel supply manifold. See FUEL LINE CONNECTORS . Disconnect fuel injector wiring harness connectors. Remove PCV hose.
  3. Remove EGR valve-to-exhaust manifold tube. Disconnect EGR valve and EGR transducer hoses. Disconnect vapor management valve hose. Remove fuel supply manifold retaining bolts. Remove fuel supply manifold with injectors by pulling on injectors while using a rocking motion. Carefully disengage fuel injectors from supply manifold. To install, reverse removal procedure. See Fig 1. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .
Fig 1: Exploded View Of Typical Fuel Injection System
G95H26879Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals