LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Controls - Removal, Overhaul & Installation -- ECONOLINE, Excursion & F250-F550 Super Duty - Gasoline) >> Computerized Engine Controls >> Powertrain Control Module >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Ford RV Cutaway, 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, and 2002 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable.
  2. Remove any component(s) necessary to gain access to PCM. For PCM location, see PCM LOCATION  table.
  3. Loosen PCM harness connector retaining bolt.
  4. Unplug harness connector from PCM. Remove 2 PCM mounting bolts.
  5. Remove PCM cover and PCM. On Excursion and F250/F550 Super Duty Pickup, removal of left front fender liner may be necessary to remove PCM connector.
  6. To install, reverse removal procedure.
  7. Tighten bracket bolts and PCM harness connector bolt to specification. See TORQUE SPECIFICATIONS .
PCM LOCATION

Model Location
Econoline Left Side Of Engine Compartment, Near Master Cylinder
Excursion & F250/F550 Super Duty Pickup Behind Left Side Of Instrument Panel, Near Brake Pedal, Through Bulkhead
scientia non olet · About LEMON Manuals