LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 839 (Exterior Lighting) >> Removal And Installation >> Lamp Assembly - Tail Lamp >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: RH shown; LH similar.
  1. Remove the rear lamp screws.
    Fig 1: Removing Rear Lamp Screws
    G03890533Courtesy of FORD MOTOR CO.
  2. Pull the rear lamp forward.
    Fig 2: Pulling Rear Lamp Forward
    G03890534Courtesy of FORD MOTOR CO.
  3. Disconnect the electrical connectors.
  4. To install, reverse the removal procedure.