LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 839 (Exterior Lighting) >> Diagnosis And Testing >> Headlamps >> Pinpoint Tests >> Pinpoint Test B: The Low Beams Are Inoperative

Pinpoint Test B: The Low Beams Are Inoperative

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. B1 CHECK THE HIGH BEAM HEADLAMPS 
    • Key in OFF position.
    • Place the headlamp switch to the headlamps ON position.
    • Place the multifunction switch to the high beam position.
    • Do the high beams illuminate? 
  2. B2 CHECK THE MULTIFUNCTION SWITCH 
    • Disconnect: Multifunction Switch C202b.
    • Carry out the multifunction switch component test. Refer to COMPONENT TESTING for component testing.
    • Is the multifunction switch OK? 
    • Yes  : REPAIR circuit 13 (RD/BK). TEST the system for normal operation.
    • No  : INSTALL a new multifunction switch. REFER to STEERING COLUMN SWITCHES . TEST the system for normal operation.
scientia non olet · About LEMON Manuals