LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Engine Controls - Removal, Overhaul & Installation) >> Fuel Systems >> Fuel Pressure Regulator >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Mercury Grand Marquis, 2002 Lincoln Town Car, and 2002 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removing fuel pressure regulator while fuel injection supply manifold assembly is still installed on engine, release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE .
  2. Remove vacuum hose at fuel pressure regulator. Disconnect fuel return hose. Remove fuel pressure regulator clip. Remove fuel pressure regulator assembly, gasket and discard "O" ring.
  3. To install, ensure sealing surfaces are clean. Lubricate NEW "O" ring with clean 5W-30 engine oil. Install NEW "O" ring on fuel pressure regulator. Install fuel pressure regulator on fuel injection supply manifold assembly, and install clip. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals