LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 815 (Automatic Transmission - 5R110W) >> In-Vehicle Repair >> Transmission Support CROSSMEMBER >> Removal

Transmission Support CROSSMEMBER: Removal

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Install a suitable high-lift transmission jack.
  3. Remove the two wire harness retainers from the rear crossmember and position the wire harness out of the way.
    Fig 1: Identifying Retaining Clips At Rear Of Crossmember
    G03889060Courtesy of FORD MOTOR CO.
  4. Remove the LH crossmember nuts.
    Fig 2: Removing LH Crossmember Nuts
    G03889061Courtesy of FORD MOTOR CO.
  5. Remove the LH crossmember bracket.
    Fig 3: Locating LH Crossmember Bracket
    G03889062Courtesy of FORD MOTOR CO.
  6. Remove the RH crossmember nuts.
    Fig 4: Removing RH Crossmember Nuts
    G03889063Courtesy of FORD MOTOR CO.
  7. Remove the RH crossmember bracket.
    Fig 5: Locating RH Crossmember Bracket
    G03889064Courtesy of FORD MOTOR CO.
  8. Remove the rear transmission mount nuts and the rear crossmember.
    Fig 6: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals