LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 815 (Automatic Transmission - 5R110W) >> In-Vehicle Repair >> Extension Housing Seal >> Removal

Extension Housing Seal: Removal

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Remove the driveshaft. For additional information, refer to DRIVESHAFT .

    2. Vehicles with a fixed flange 

  2. Remove the output shaft flange.
    1. Remove and discard the output shaft flange bolt.
    2. Remove the output shaft flange.
      Fig 1: Removing Output Shaft Flange
      G03889089Courtesy of FORD MOTOR CO.
  3. Using the special tool, remove and discard the output shaft nut.
    Fig 2: Removing Output Shaft Nut Using Special Tool
    G03889090Courtesy of FORD MOTOR CO.
  4. Using the special tools, remove the output shaft seal.
    Fig 3: Removing Output Shaft Seal
    G03889091Courtesy of FORD MOTOR CO.

    5. Vehicles without a fixed flange 

  5. Using the special tools, remove the extension housing seal.
    Fig 4: Removing Extension Housing Seal
    G03889092Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals