LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 815 (Automatic Transmission - 5R110W) >> General Procedures >> Torque Converter

Torque Converter

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. A new or remanufactured torque converter must be installed if one or more of the following statements are true:
    • A torque converter malfunction has been determined based on the complete diagnostic procedures.
    • Converter stud(s), impeller hub or bushing is damaged.
    • Discoloration of the torque converter (due to overheating).
    • Evidence of transmission assembly or fluid contamination due to the following transmission or converter failure modes:
      • Major metallic failure.
      • Multiple clutches or clutch plate failures.
      • Sufficient component wear which results in metallic contamination.
        Fig 1: Identifying Torque Converter
        G03889035Courtesy of FORD MOTOR CO.