Torque Converter Diagnosis: Notes

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Prior to torque converter replacement, all diagnostic procedures must be followed. This is to prevent the unnecessary installation of new or remanufactured torque converters. Only after a complete diagnostic evaluation can the decision be made to install new or remanufactured torque converters.

Begin with the normal diagnostic procedures as follows:

Preliminary Inspection.
Know and Understand the Customer's Concern.
Verify the Concern - Carry out the Torque Converter Operation Test .
Carry out Diagnostic Procedures.
- Run on-board diagnostics. Refer to ON-BOARD DIAGNOSTICS WITH DIAGNOSTIC TOOL .
  - Repair all non-transmission-related DTCs first.
  - Repair all transmission DTCs.
  - Rerun on-board diagnostics to verify repair.
- Carry out Line Pressure Test .
- Carry out Stall Speed Test .
- Carry out Diagnostic Routines .
  - Use the Diagnosis by Symptom Index to locate the appropriate routine that best describes the symptom(s). The routine will list all possible components that may cause or contribute to the symptom. Check each component listed. Diagnose and repair as required, before repairing the torque converter.