LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 815 (Automatic Transmission - 5R110W) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> TCC Does Not Apply

TCC Does Not Apply

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC ROUTINES - TCC DOES NOT APPLY

Possible Component Reference/Action
250 - ROUTINE 
Powertrain Control System   
  • PCM, vehicle wiring harnesses, transmission internal wiring harness, transmission line pressure solenoid PC-A, TCC, TFT, Transmission Range (TR position) sensor, OSS
Incorrect Pressures   
  • Low pressures
Solenoid Body Assembly   
  • Bolts not tightened to specification
  • Tighten to specification.
  • Filter gasket damaged
  • Inspect for damage. If damaged, install a new filter gasket.
  • Contamination
  • Disassemble and clean.
  • SSPC-A, SSPC-B, TCC solenoid(s) damaged, misassembled, missing, stuck or bore damaged. Manual valve damaged, misassembled, missing, stuck or bore damaged
  • If damaged or parts are missing, install a new solenoid body assembly. If misassembled, reassemble correctly.
Fluid Pump Assembly   
  • Bolts not tightened to specification
  • Tighten to specification.
  • Filter gasket damaged
  • Inspect for damage. If damaged, install a new filter gasket.
  • Porosity, cross leaks, cup plug missing, plugged hole
  • Inspect for damage. If damaged, repair as necessary.
  • Pump gears and/or gear pocket damaged
  • Inspect for damage. Install a new pump.
  • Control valves, converter charge limit valve, converter pressure regulator valve springs, or seals damaged, stuck or not assembled correctly
  • Inspect for damage. Install a new seal or pump assembly.
Torque Converter   
  • Internal failure preventing TCC to apply
  • Remove transmission. Inspect for damage. Carry out torque converter checks, refer to TORQUE CONVERTER . If torque converter fails to pass checks or is damaged, install a new or remanufactured torque converter.