Engine Will Not Crank

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

DIAGNOSTIC ROUTINES - ENGINE WILL NOT CRANK

Possible Component	Reference/Action
258 - ROUTINE
Powertrain Control System
NOTE: If the battery has been disconnected or is dead, the transmission shifts and engagements will feel firm. Carry out Routine 267. PCM, vehicle wiring harnesses, vehicle starter transmission internal harness, Transmission Range (TR position) sensor, PATS module	Carry out on-board diagnostic tests. See INTRODUCTION - GASOLINE and/or INTRODUCTION -- 6.0L DIESEL articles for diagnosis and testing of the PCM. GO to PINPOINT TEST C . Check PIDs for TR position, PARK and NEUTRAL. Repair as required. Clear DTCs, road test and carry out on-board diagnostic test again.
Engine Components
Sensors, solenoids, fan clutch damaged or shorted to ground	Inspect and repair as necessary. Refer to Engine - 6.0L Diesel . See INTRODUCTION - GASOLINE and/or INTRODUCTION -- 6.0L DIESEL articles .
Vehicle Starter
Starter damaged	Inspect and repair as necessary. Refer to STARTING SYSTEM - DIESEL ENGINE .
External Shift Cable System
Cable system damaged, misaligned	Inspect and repair as necessary. Refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS .
TR position Sensor Assembly
TR position assembly damaged	Inspect and repair as necessary.
Fluid Pump Assembly
Internal parts seized	Inspect for damage and repair as necessary.
Torque Converter
Flex plate damaged	Inspect for damage and repair as necessary.