LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 814 (Automatic Transmission - 4R70W, 4R75W) >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING for E-series, or JACKING & LIFTING - F150 PICKUP .
  2. Disconnect the output shaft speed (OSS) sensor electrical connector.
  3. Remove the OSS sensor bolt and sensor.
    • Remove the OSS sensor bolt.
    • Remove the OSS sensor.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals