Shift Concerns: Feel - Soft/Slipping

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

SHIFT CONCERNS: FEEL - SOFT/SLIPPING

Possible Component	Reference/Action
213 - ELECTRICAL ROUTINE
Powertrain Control System
Electrical inputs/outputs, vehicle wiring harnesses, PCM, EPC solenoid, OSS	Carry out Self-Test. See INTRODUCTION - GASOLINE and/or INTRODUCTION -- 6.0L DIESEL articles for diagnosis and testing of the Powertrain Control System. GO to PINPOINT TEST D or GO to PINPOINT TEST E . Repair as required. Clear DTCs, road test and repeat Self-Test.
Engine driveability concerns	Refer to Routine 253 under OTHER CONCERNS: POOR VEHICLE PERFORMANCE .
313 - HYDRAULIC/MECHANICAL ROUTINE
Fluid
Incorrect level	Adjust fluid to correct level.
Condition	Inspect condition of fluid.
Incorrect Pressures
Low line pressure, low EPC pressure	Check pressures at line and EPC taps. Refer to the LINE PRESSURE CHART for specifications. Refer to SPECIAL TESTING PROCEDURES . If pressures are low or all shifts are soft/slipping, go to Main Controls. If pressures are OK and a specific shift is soft/slipping, refer to the following routine(s) for further diagnosis: Shift 1 - 2, Routine 320 Shift 2 - 3, Routine 321 Shift 3 - 4, Routine 322 Shift 4-3, Routine 323 Shift 3-2, Routine 324 Shift 2-1, Routine 325
Main Controls
Main regulator valve, overdrive servo regulator valve stuck, damaged or assembled incorrectly	Inspect for damage. Repair as required.
EPC solenoid stuck or damaged	Inspect for damage and contamination. Carry out EPC tests in Routine 213. Repair as required.
Case
1 - 2 accumulator stuck or damaged	Inspect for damage. Repair as required.
Filter and Seal Assembly
Filter plugged, damaged	Inspect for damage. Install a new filter as required.
Seal damaged or cut	Inspect for damage. Install new as required.