LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 813 (Electronic Engine Controls - Diesel Engine) >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
    2. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
  2. Turn the ignition switch to the OFF position.
    3. NOTE: The CMP sensor is located behind the power steering pump.
    Fig 1: Locating Camshaft Position Sensor Electrical Connector
    G03888384Courtesy of FORD MOTOR CO.
  3. Disconnect the camshaft position (CMP) sensor electrical connector.
  4. Remove the bolt and the CMP sensor.
    Fig 2: Removing Bolt And CMP Sensor
    G03887650Courtesy of FORD MOTOR CO.
    5. NOTE: Apply clean engine oil to the O-ring seal before installation.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals