LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 812 (Electronic Engine Controls - Gasoline Engines) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor - 4.6L, 5.4L, 6.8L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to ENGINE - 4.6L AND 5.4L or Engine - 6.8L .
  2. Disconnect the cylinder head temperature (CHT) sensor electrical connector.
    Fig 1: Disconnecting Cylinder Head Temperature (CHT) Sensor Electrical Connector
    G03888379Courtesy of FORD MOTOR CO.
  3. Remove the CHT sensor.
    Fig 2: Removing CHT Sensor
    G03888380Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals