LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 809 (Interior Trim And Ornamentation) >> Removal And Installation >> A-Pillar Trim Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Right side shown, left side similar.
  1. Remove the right front assist handle covers.
    Fig 1: Removing Right Front Assist Handle Covers
    G03890685Courtesy of FORD MOTOR CO.
  2. Remove the assist handle bolts.
    Fig 2: Removing Assist Handle Bolts
    G03890686Courtesy of FORD MOTOR CO.
  3. Remove the assist handle.
  4. NOTE: Pull down at the top of the A-pillar trim panel to release upper retaining clip.
    Fig 3: Pulling Down At Top Of A-Pillar Trim Panel
    G03890687Courtesy of FORD MOTOR CO.
  5. Pull the A-pillar trim panel downward to release the remaining two retaining clips.
  6. To install, reverse the removal procedure.