LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 806 (Starting System - Diesel Engine -- E350 &E450 (99P E-Series)) >> Diagnosis And Testing >> Starting System >> Component Tests >> Starter Motor - No-Load Test >> Notes

Starter Motor - No-Load Test: Notes

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect a fully charged battery to the starter.
  2. Connect the alternator, regulator, battery and starter tester (ARBST).
  3. Connect a remote starter switch between the starter solenoid Terminal S and the positive battery terminal post.
  4. Press the remote starter switch. The pinion should shift to the crank position and the motor should run smoothly.
  5. While the starter motor is running, record the voltmeter and ammeter readings.
  6. The voltage reading should be greater than 11.0 volts and the amperage should be no more than 170 amps.
  7. If the voltage is lower than specified or amperage is higher than specified, refer to the RESULTS CHART  below to determine possible cause and corrective action.
scientia non olet · About LEMON Manuals