LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 805 (Starting System - Gasoline Engines) >> Removal And Installation >> Starter Motor >> Removal

Starter Motor: Removal

WARNING: This page is about a different car, the 2005 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Raise and support the vehicle. For additional information, refer to JACKING & LIFTING .
  3. Remove the starter motor solenoid terminal cover.
    Fig 1: Identifying Starter Motor Solenoid Terminal Cover
    G03886928Courtesy of FORD MOTOR CO.
  4. Disconnect the starter motor electrical connections.
    Fig 2: Disconnecting Starter Motor Electrical Connections
    G03886608Courtesy of FORD MOTOR CO.
  5. Remove the starter.
    1. Remove the stud bolt.
    2. Remove the two bolts.
    3. Remove the starter.
      Fig 3: Removing Starter
      G03886609Courtesy of FORD MOTOR CO.