Pinpoint Test C: The Engine Cranks Slowly
WARNING: This page is about a different car, the 2005 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before beginning this test, be sure that the battery is tested and fully charged.
- C1 CHECK THE VOLTAGE TO THE STARTER
- Key in OFF position.
- Measure the voltage between starter motor solenoid positive terminal and ground.
- Is the voltage 12.5 volts or greater?
- Yes : GO to C2.
- No : REPAIR the circuit between the battery and the starter solenoid. CLEAN and TIGHTEN the connections at the battery terminals. TEST the system for normal operation.
- C2 CHECK THE MOTOR GROUND CIRCUIT
- Carry out the motor ground circuit test. Refer to the COMPONENT TESTS .
- Is the ground OK?
- Yes : INSTALL a new starter motor. TEST the system for normal operation.
- No : REPAIR the ground circuit as necessary. TEST the system for normal operation.