LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Steering Column) >> Removal & Installation >> Steering Column >> Removal

Steering Column: Removal

WARNING: This page is about a different car, the 1999 Mercury Mystique, 1999 Mercury Cougar, 1999 Ford Contour, 1998 Mercury Mystique, and 1998 Ford Contour. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure front wheels are in straight-ahead position. Turn lock cylinder to LOCK position and rotate steering wheel counterclockwise until locked. Disconnect negative battery cable. Disconnect positive battery cable. Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM  .
  2. Remove steering column cover. Remove driver side instrument panel lower panel. Remove upper and lower steering column shrouds.
  3. Disconnect all steering column electrical connectors. On vehicles with console shift, remove interlock cable from column.
  4. Remove bolt from steering shaft-to-intermediate shaft connecting clamp. Loosen connecting clamp.
  5. Remove steering column mounting nuts. Inspect mounting bracket clips. Replace, if damaged. Steering column will not function properly if clips are not installed.
  6. Pry open slot in steering shaft near connecting clamp. DO NOT use excessive force. Disengage steering shaft from intermediate shaft. Remove steering column.
scientia non olet · About LEMON Manuals